Conveyor bed not working (Slat and honeycomb types)

Check the following:-

• Do you have the correct cutter driver loaded in your cutter set-up?
  For example: FB750 Conveyor
  
• Is the Sheet and Roll button on in the cutter set-up?(black dot is on)
  
• With the cutter powered off, can the bed surface be moved by hand?
  (Note, there is significant gearing on the drive train, and this will need to be accounted for in your assessment of free movement)
  
• Is there any cutting debris trapped in the chains or drive sprockets (check carefully)
  
• Are there any retaining screws missing from the slats?
  
• Are any slat retaining screws interfering with the mechanism?
  
• Are any guards / cutting debris causing an obstruction to table movement?
  
• Is the pressure roller at the table rear free to rotate?
  
• Can the material roll be pulled onto the bed easily enough from the stand?
  
• Have the drive chains / sprockets been oiled recently?
  
• Is anything trapped in the main drive belt teeth from the gearbox? (On some models the gearbox / motor is under the slats in the centre of the bed and on 7 series models mounted to the machine chassis at the front RH side.
  
• If the cutter beeps when attempting to drive the bed and there is a problem, the following will appear in the LCD display: “ Y2 axis error”.
  
• The beep may indicate a problem with the drive motor / encoder but check the above points first before condemning the motor / encoder drive unit.

CadCam Technology Ltd
5 Crocus Street
Nottingham
NG2 3DE
UK

+44 (0) 115 844 8050